The perfume bottle plastic mold parting surface, fixed distance parting tissue clutter, the launch mode, a novel arrangement disorder, manufacturing cost is higher, but the special needs of satisfactory plastic parts: Keywords perfume bottle; runner system; die launch organization; push mode; buckle. Perfume bottle, plastic parts to the deep cavity of cylinder parts, materials for transparent Pc, appearance is not allowed to have traces of the gate and push rod. Plastic parts appearance demand is very high. The utility model is characterized in that the utility model is characterized in that two cavities are arranged in a mold, and the inner part of the utility model is dumped into the barge, and the well is made to be rolled out to be put into the organization. Layout saddle for clutter. The gate pin point gate injection mold plastic parts in the external appearance, the push rod arranged on the plastic parts inside and outside the table, after opening the plastic parts left in the dynamic model, and then by the dynamic organization launched the introduction of plastic parts, the mold structure is simple, reliable action. But in this case, the introduction of the organization and the gate must be in the same plane of the mold. Because the gate can only be set in the mold, perfume bottle, so the introduction of the organization must also be in the mold, which is called the reverse push die. Plastic parts for a car perfume bottle, belonging to deep cavity cylinder parts, materials for transparent Pc. The appearance of plastic parts is very high, the appearance is not allowed to have the gate and putter marks. Therefore, the appearance of plastic parts by the dynamic molding, internal and external table by the fixed mold, into the gate of plastic parts. Other plastic parts inside the side there are two buttons, so the mold pouring system and the introduction of the system is the key points and difficulties in mold design: 1, plastic parts of the circumference of the surface of the three side holes, mold design to the end of the core block. 2, plastic parts in the circumferential surface of the buckle position, can not choose the diagonal rod core pulling, or plastic parts appearance quality is not up to demand. The mold design uses the fixed mold inside the slide block, the mold manufacture cost is higher, but can satisfy the plastic piece the quality demand. 3, because the plastic parts are not allowed to have traces of the mold, the use of fixed die plate. Die layout: (1) pouring system. Is a mold two cavity, plastic parts to deep cavity cylindrical parts, in order to quickly melt filling and gas discharge cavity, the gate must be in plastic parts of the inner surface of the middle, so the point gate mould pouring system, the gate can automatically drop, the layout of the mold. (2) cooling system. Plastic parts are cylindrical parts, cooling system is the key point of die design, which directly affects the productivity of the mould. In order to better and faster cooling, the mold core of the model uses a spiral trough, the dynamic model of the core of the selection of double decker. Practice has proved that this cooling effect is excellent. (3) molded parts. The mold molding part mainly includes cavity, core module inserts, moving die insert, in order to repair processing and cooling facilities, movable and fixed mould inserts are used combined; the molding part also contains two lateral core pulling and four fixed die inside core pulling, lateral pumping with the core of "T" type of locking block and block layout; die inside core pulling the slider with bending pin layout. Want to know more about the perfume bottle, welcomed the attention of Guangzhou Yuanchang official website: http://www.blyuanchang.com/ Plastic pump, cosmetic foam pump, plastic cap, cosmetic spray nozzle